Silver Bullnose Edge Board

MIGHTY DECK Composite Bullnose Edge boards are 3.66 Metres long X 137  X 25 mm, with wood grain on one side and grooved on the other.

Each board comes with a pack of 6 bullnose braces with square drive screws, for securing the board to the subframe on the Bullnose Edge side. Every delivery also comes with a free Square Drive Drill Bit.

For securing the grooved side of the board you will need a T or SS clip for bullnoses laid length ways but if you are installing bullnose boards against board ends, you will need starter clips.

If you'd prefer to secure your Bullnose Board by screws through the top and into the subframe, you could buy our matching "fascia screws", for this purpose, however please ensure you make a pilot hole, 6 or 7 mm wide, to allow for expansion and contraction.

Bullnose boards are used mainly when you have exposed edges of decking areas that you would like to finish off with a matching or contrasting full width board with a rounded edge on the outside. When mitred at the corner ends they create a fabulous "picture frame" around  your composite decking area, steps  planters and anything else you are making with composite boards.

See here on the next image, our collage of photos of Bullnose Edge Boards installed.

Silver Mighty Deck:

Slide to see our collage of photos of Silver Mighty Deck in a variety of outdoor living areas and designs. The boards start as a light grey with light blue undertones and will fade and develop so the blue undertones merge into the light grey to produce a stunning, cool light grey. Once it reaches this fabulous colour , the weathering process is complete. Please do bear in mind that the photos are taken with different cameras, in different lighting, times of day and times of year and the colours you see on your screen will also be dependent on your settings, so if you are looking for a particular shade of Silver or Light grey, we advise you either visit our outdoor displays here in Whitstable, or order a sample, leave it outside for a while and check if it weathers to the shade you are looking for.

If you have any queries, or need help working out quantities needed, please don't hesitate to contact our friendly knowledgeable team.

Quantities

To work out the number of Bullnose Edge Boards you need simply measure the total outer edge lengths you require, divide by 3.66 and “round up”, this will give you the number of Bullnose Edge Boards to order.

About Mighty Deck Boards

Mighty Deck, is named so,  as it is one of the strongest, most slip resistant composite decking products. Mighty Deck has been tested for slip resistance using the Pendulum Test, tested to British Standards BS7976 and resulted in a Pendulum Test Value (PTV) of 41 longitudinal and 43 horizontal. A PTV value of over 36 means there is a low slip potential ( lower than 1 in 1 million ) so Mighty Deck is an excellent choice if slip resistance is a priority.

The tests are done on clean decking so to maintain the slip resistance as well as the aesthetics you will of course need to remove/wash off snow, ice, grime etc.

Installation

To ensure you enjoy your decking area for many years to come and to be covered under the 10 year warranty MIGHTY DECK Composite Bullnose Edge boards are 3.66 Metres long X 137  X 25 mm, with wood grain on one side and grooved on the other.

Terms & Conditions